Form metal tape into V or W profile for hoop of SWG with thickness 4.5mm and 3.2 mm, other width on request. The speed can be adjusted. U profile for eyelets of reinforced graphite gasket is also available.

Cut graphite, PTFE, (Non) asbestos sheet /roll into tape with for filler of SWG with thick. 4.5mm and 3.2mm, Special width on request.

Cut metal foil into tape for hoop of SWG with thick. 4.5mm and 3.2mm, Other width for eyelets of reinforced graphite gaskets on request.

This machine can make kammprofile gasket or strip in any size, the profile shape can be request. It is CAZ new design It is economical to make Kammprofile gaskets by bending.

This small special lathes can process inner and outer rings of SWG easily and with great efficiency and speed for size small than 300mm

For making tanged metal sheet. It is efficient with double line needle. Change single needles easily, and low cost. Dia. Of needle: ¦µ1.2mm, ¦µ1.5, for complex sheet thick.1.2~1.6mm, and 1.5~3.0mm

To compound graphite, asbestos and non-asbestos etc non-metallic sheet reinforced with tanged or smooth metal foil insertion. Roller Dia.300mm is normal for width 1000mm, and dia.350mm or 400mm for width 1500mm

To cut non(semi)-metallic round gaskets or segments, inner and outer dia. Is finished synchronously. Especially for making reinforced graphite gasket.

Forming flat metal tape into U profile for eyelets of cutting gaskets The speed can be adjusted.