This small special lathes can process inner and outer rings of SWG easily and with great efficiency and speed for size small than 300mm

For making tanged metal sheet. It is efficient with double line needle. Change single needles easily, and low cost. Dia. Of needle: ��1.2mm, ��1.5, for complex sheet thick.1.2~1.6mm, and 1.5~3.0mm

To compound graphite, asbestos and non-asbestos etc non-metallic sheet reinforced with tanged or smooth metal foil insertion. Roller Dia.300mm is normal for width 1000mm, and dia.350mm or 400mm for width 1500mm

To cut non(semi)-metallic round gaskets or segments, inner and outer dia. Is finished synchronously. Especially for making reinforced graphite gasket.

Forming flat metal tape into U profile for eyelets of cutting gaskets The speed can be adjusted.

Fixing U profile metal tape to inner or outer border of gasket by roller. The metal eyelets can offer special protection against blowout and chemical attack, also improve seal-ability due to the local higher stress under eyelets.

For making double jacketed gasket This machine can finish making U profile and then planish metal segment or gaskets with filler and cover board. It needs small rollers /moulds for different sealing width.

Stop automatic while yarn broken; Impregnated lubrication and heated during braiding; The pull can be adjusted 1~4kg; Braided tightly; Show output; Lower noise;

Copy from Germany. Stop automatic while yarn broken; Impregnated lubrication and heated during braiding; The pull can be adjusted 1~4kg; Braided tightly; Show output; Lower noise;